2004 jeep grand cherokee driver door wiring diagram problems

2004 Jeep Grand Cherokee Driver Door Wiring Diagram 08 Impala

The contact owns a 2004 Jeep Grand Cherokee. The contact stated that the wiring harness is located on the driver's side door, but the harness is too small to sustain all the wires. Jul 17, 2017 Sep 14, 2019 2004 Jeep Grand Cherokee Door Wiring Harness Diagram– wiring diagram is a simplified gratifying pictorial representation of an electrical circuit.It shows the components of the circuit as simplified shapes, and the aptitude and signal connections surrounded by the devices. The fuse panel on the passanger sid read more. I am looking for a wiring diagram for the power window system in my 2000 jeep cherokee sport. Beauty studio hair master 4 4.0 crack. The problem is none of the windows other than the drivers window work. I think the problem is with the chi read more. 2000 jeep cherokee: passenger front window will not go up. Need Wiring Diagram For 2004 Jeep Grand Cherokee Power Window Circuits pertaining to Cherokee Wiring Diagram by admin Through the thousands of pictures on the web in relation to cherokee wiring diagram, choices the top selections together with ideal resolution just for you all, and now this photographs is considered one of photographs selections in our very best images gallery about Cherokee.

PART	COLOR	LOCATION
12 VOLT CONSTANT	PINK/BLACK (+) and RED (+)	IGNITION SWITCH HARNESS
STARTER	YELLOW (+)	IGNITION SWITCH HARNESS
STARTER 2	N/A
IGNITION 1	DARK BLUE (+)	IGNITION SWITCH HARNESS
IGNITION 2	N/A	IGNITION SWITCH HARNESS
IGNITION 3	N/A
ACCESSORY/HEATER BLOWER 1	RED/BLACK (+)	IGNITION SWITCH HARNESS
ACCESSORY/HEATER BLOWER 2	BLACK/ORANGE (+)	IGNITION SWITCH HARNESS
KEYSENSE	N/A
PARKING LIGHTS ( - )	YELLOW (-) See NOTE *2	@ HEADLIGHT SWITCH, See DIAGRAM
PARKING LIGHTS ( + )	DO NOT USE!
POWER LOCK	ORANGE/VIOLET and PINK/BLACK (TYPE C) See NOTE *1	IN BOTH FRONT DOORS, See DIAGRAM
POWER UNLOCK	PINK/BLACK (TYPE C) See NOTE *1	IN BOTH FRONT DOORS, See DIAGRAM
DOOR TRIGGER	See NOTE *3
DOMELIGHT SUPERVISION	YELLOW/DARK GREEN (-)	@ BCM, above DIAGNOSTIC PLUG
TRUNK RELEASE	N/A
SLIDING POWER DOOR	N/A
HORN	GRAY/ORANGE (-)	@ HORN SWITCH
TACH	See NOTE *4
WAIT TO START LIGHT	N/A
BRAKE	WHITE/TAN (+) (1999-2003) WHITE/TAN or PURPLE/BROWN (+) (2004)	@ SWITCH ABOVE BRAKE PEDAL
FACTORY ALARM DISARM	LIGHT GREEN/ORANGE (-) See NOTE *5	@ DRIVERS DOOR LOCK SWITCH in DRIVERS DOOR
ANTI-THEFT	CHRYSLER'S SENTRY KEY, A TRANSPONDER SYSTEM	TRANSPONDER @ IGNITION SWITCH TUMBLER

2004 Jeep Grand Cherokee Driver Door Wiring Diagram Problems

2004 Jeep Grand Cherokee Driver Door Wiring Diagram

EXTRA INFORMATION

NOTE *1 Use ORANGE/VIOLET for LOCK and PINK/BLACK for UNLOCK at the DRIVERS DOOR SWITCH. Use BLACK/WHITE for LOCK and PINK/BLACK for UNLOCK at the passenger front door switch. This vehicle requires (2) of part # 778 one for each door See DIAGRAM. TO AVOID INSTALLING RELAYS IN BOTH DOORS.. USE INTERFACE MODULE Part # XK09 or DB-ALL. These are combo modules that bypass the Anti-theft and enable the use of keyless entry without adding relays. To make a keyless entry system work you can create the circuit above using (2) #778 realys but it's recommended to use the XK09 or DB-ALL. NOTE *2 the YELLOW Parking light wire will require a (-) Negative thru a 1300 Ohm resistor and a extra relay part #775, to connect, See DIAGRAM. NOTE *3 this vehicle has 4 Door trigger input wires, the DRIVERS DOOR is a TAN/RED (-) at the DRIVERS DOOR LOCK SWITCH, the PASSENGER DOOR is a TAN/RED (-) at the PASSENGER DOOR LOCK SWITCH, the DRIVERS REAR DOOR is a TAN/ORANGE (-) and the PASSENGER REAR DOOR is a TAN/YELLOW (-) both are at the BCM (Body Control Module), when connecting to an ALARM SYSTEM you must BOTH DOOR TRIGGER wires and DIODE ISOLATE, to connect, See DIAGRAM NOTE *4 on the 4.7L engine, go to any coil and use any wire that is NOT DARK GREEN/ORANGE. On the 4.0L engine, use any wire with a TAN STRIPE at the coil pack NOTE *5 to DISARM the FACTORY ALARM SYSTREM requires a (-) NEGATIVE thru a 463 Ohm Resistor and an extra relay part #775, to connect, See DIAGRAM NOTE***** the BCM (Body Control Module) is located above the DIAGNOSTIC PLUG under the dash.